INSTALLATION GUIDE

Step One - Check that the supporting wall is strong enough to hold an 8 or 10mm thick pain of glass.

Step Two - Using 2 people, hold the glass board up to the wall, and mark the fixing points with a pencil. Drill, then take the brackets marked Part 1, and fix them to the wall using suitable wall plugs.

Step Three - Clean the side of the glass that will sit against the wall. Place the washers (supplied) either side of hole in the glass panel, then align the Glass Wipe Board over the brackets and screw Part 2 into Part 1. Use an allen key to tighten just slightly more than hand tight.